Chapter 6: Configuring Telnet; Setting Telnet Access; Displaying Telnet Access Current Settings - Avaya 3500 series Getting Started

Chapter 6: Configuring Telnet

Setting Telnet access

You can access ACLI through a Telnet session. To access ACLI remotely, the management
port must have an assigned IP address and remote access must be enabled. you can log on
to the switch using Telnet from a terminal that has access to the Avaya Ethernet Routing Switch
3500 Series.
Important:
Multiple users can access the ACLI system simultaneously, through a serial port, Telnet, and
modems. The maximum number of simultaneous users is four plus one at the serial port,
for a total of five users on the switch. All users can configure simultaneously.
You can view the Telnet-allowed IP addresses and settings, change the settings, or disable
the Telnet connection.

Displaying Telnet access current settings

Display the current settings for Telnet access.
Procedure
1. Log on to the ACLI Privileged EXEC command mode.
2. At the command prompt, enter the following command:
Example
The following figure displays sample output for the show telnet-access command.
3524GT-PWR+(config)#show telnet-access
TELNET Access:
Login Timeout:
Login Retries:
Inactivity Timeout:
Event Logging:
Allowed Source IP Address
-------------------------
1 0.0.0.0
Getting Started
show telnet-access
Enabled
1 minute(s)
3
15 minute(s)
All
Allowed Source Mask
--------------------
0.0.0.0
March 2013 35