Chapter 13: Configuring the switch using
Configuring Quick Start using EDM
Perform this procedure to configure Quick Start to enter the setup mode through a single
screen.
Procedure
1. From the navigation tree, click Administration.
2. In the Administration Tree, click Quick Start.
3. In the In-Band Switch IP address, type a switch address.
4. In the In-Band Subnet Mask dialog box, type a subnet mask.
5. In the Default Gateway dialog box, type an IP address.
6. In the Read-Only Community String box, type a character string.
7. In the Re-enter to verify dialog box immediately following the Read-Only
8. In the Read-Write Community String dialog box, type a character string.
9. In the Re-enter to verify dialog box immediately following the Read-Write
10. In the Quick Start VLAN dialog box, type a VLAN ID.
Getting Started
EDM
Community String box, retype the character string from Step 6.
Community String box, retype the character string from Step 8.
March 2013
95