Configuring The Asset Id Using Edm; Selecting The Acli Banner Type Using Edm - Avaya 3500 series Getting Started

Configuring the switch using EDM
Name
CurrentDefaultGateway
NextBootLoadProtocol
LastLoadProtocol

Configuring the Asset ID using EDM

Use this procedure to configure the Asset ID for a switch.
Procedure
1. In the navigation tree, double-click Edit.
2. In the Edit tree, double-click Chassis.
3. In the Chassis tree, click Chassis.
4. In the work area, click the Asset ID tab.
5. In the table, click the cell under the Asset ID column heading.
6. In the Asset ID field, enter an alphanumeric value, up to 32 characters.
7. On the toolbar, click Apply.

Selecting the ACLI banner type using EDM

Use this procedure to select the type of banner that is displayed in the Avaya Command Line
(ACLI) Telnet screen.
Procedure
1. In the navigation tree, click Edit.
2. In the Edit tree, click Chassis.
3. In the Chassis tree, click Chassis.
102 Getting Started
Description
Indicates the address of the default gateway
that is currently in use. This is a read-only
item.
Indicates the transport protocol that the
agent uses to load the configuration
information and the image at the next boot.
This is a read-only item.
Indicates the transport protocol last used to
load the image and configuration information
about the switch. This is a read-only item.
Comments? infodev@avaya.com
March 2013