Displaying the Power System Statistics
Web Agent
Procedure
Document No. 10-300077, Issue 2
You can display the statistics for your switch's power system from the either
the Web Agent and the CLI.
To display your switch's power system statistics using the Web Agent:
1. In the navigation pane, expand the System > Configuration folders, and
then click Power System.
The Power System Web page is displayed in the content pane and
displays your switch's current power statistics. See
Figure 3-8. Power System Web Page
2. See
Table 3-3
and review the Power System Web page parameters:
Table 3-3. Power System Web Page Parameters
Parameter
Power Supply
Status
Type
Total System Power
Current Power Available
* Note: The Total System Power field displays 1400 Watts if three
power supplies are installed. The switch uses power from only
Configuring System Information
Definition
Identifies the power supply
indicates whether the power supply is detected.
Describes the type of power supply detected.
Displays the total system power in Watts.
Displays the current power available.
Figure
3-8.
3-15