Displaying Ip Configuration - Avaya 3500 series Getting Started

Variable definitions
The following table describes the parameters for the ip default-gateway command.
<A.B.C.D>
no
default

Displaying IP configuration

This procedure is used to display the IP configuration, specifically BootP mode, switch address,
subnet mask, and gateway address. These parameters are displayed for what is configured,
what is in use, and the last BootP.
Procedure
1. Logon to the ACLI in User EXEC command mode.
2. At the command prompt, enter the following command:
Getting Started
[no] [default] ip default-gateway
Variable
show ip [bootp] [default-gateway] [address [switch]] [dns]
Value
Enter the IP address of the default IP
gateway in the format XXX.XXX.XXX.XXX.
DEFAULT: 0.0.0.0.
Important:
When you change the IP gateway, you can
lose connection to Telnet and the Web.
You can also disable any new Telnet
connection required to connect to the
serial Console port to configure a new IP
Gateway address.
Clears the IP address of the default IP
gateway. Sets the IP default gateway
address to zeros (0).
Sets the IP default gateway address to all
zeros (0.0.0.0).
Displaying IP configuration
March 2013 31