netmask, default gateway, read-only and read-write community strings, quick start VLAN,IPv6
in-band address, and IPv6 default gateway.
Configuring with Quick Start using ACLI
The Install Script consists of a series of prompts that are used to set up the minimum
configuration information.
You must enter the following information when prompted:
• IP address
• Subnet mask
• Default gateway
• Read-only community string
• Read-write community string
• Quick start VLAN
Before you begin
• Connect to the switch using the terminal or terminal emulation application.
Procedure
1. Press
2. Enter enable
3. Enter install
4. Enter the IP address at the following prompt:
5. Enter the sub-net mask at the following prompt:
6. Enter the default gateway IP address at the following prompt:
7. Enter the read only community string at the following prompt:
8. Enter the read write community string at the following prompt::
9. Enter the VLAN ID for the Quick Start at the following prompt:
Getting Started
CTRL + Y to obtain a CLI prompt.
The ERS 3500 setup utility banner appears.
Please provide the in-band IP Address [0.0.0.0]:
Please provide the in-band sub-net mask [0.0.0.0]:
Please provide the Default Gateway [0.0.0.0]:
Please provide the Read-Only Community String [**********]:
Please provide the Read-Write Community String [**********]:
Please provide the Quick Start VLAN <1–4094> [1]:
Quick Start
March 2013
19