Configuring Edm Through Acli - Avaya 4550T-PWR+ Fundamentals

Configuring EDM through ACLI

This section describes how to enable and configure the Enterprise Device Manager (EDM)
using ACLI.
Enabling the Web server using ACLI
About this task
The Web server is enabled by default. If you have assigned an IP address to the switch, you
can access EDM.
If you have disabled the Web server you can use the following procedure to enable and manage
the Web server using ACLI. After you enable the Web server, you can start EDM. For more
information about the Web server, see Avaya Ethernet Routing Switch 4000 Configuration –
Security (NN47205-505).
Prerequisites
• Open an ACLI session
• Access Global Configuration mode
Procedure
To enable the Web server, enter the following command:
web-server enable
Disabling the Web server using ACLI
About this task
Use the following procedure to disable the Web server using ACLI. After you disable the Web
server, you cannot start EDM.
Prerequisites
• Open an ACLI session
• Access Global Configuration mode
Procedure
To disable the Web server, enter the following command:
no web-server enable
Fundamentals
Enterprise Device Manager procedures
December 2011 37