Receiver/Dryer Removal And Installation - Suzuki Swift Sport 2004 Service & Repair Manual

7B-22 Air Conditioning System: Manual Type
5) Remove condenser assembly (1) as shown.
1
Installation
Reverse the removal procedure to install condenser
noting the following instructions.
• Replenish specified amount of compressor oil to
compressor suction side referring to "Replenishing
Compressor Oil" in "Operation Procedure for
Refrigerant Charge".
• Evacuate and charge the A/C system referring to
"Evacuation" and "Charge" in "Operation Procedure
for Refrigerant Charge".

Receiver/Dryer Removal and Installation

Removal
1) Remove front bumper referring to "Front Bumper
and Rear Bumper Components in Section 9K".
2) Remove receiver/dryer bolt (1), and then remove
receiver/dryer (2) from condenser.
3) Remove joints (3) and O-rings (4).
I4RS0A720018-01
S7RS0B7216031
2
4
3
4
1
I7RS0A721008-01
Installation
Reverse the removal procedure noting the following
instructions.
• Replenish specified amount of compressor oil to
compressor suction side referring to "When replacing
other parts" in "Operation Procedure for Refrigerant
Charge".
• Use new receiver/dryer and O-ring.
• Do not remove plug from receiver/dryer until just
before installing it condenser.
• Apply compressor oil to O-ring.
: Compressor oil 99000–99015–00A
(MATSUSHITADENKI GU10)
• Tighten receiver/dryer bolts to the specified torque.
Tightening torque
Receiver/dryer bolt: 10 N·m (1.0 kgf-m, 7.5 lb-ft)
• Evacuate and charge the A/C system referring to
"Evacuation" and "Charge" in "Operation Procedure
for Refrigerant Charge".