9D-7 Wipers / Washers:
Rear Wiper Motor Inspection
NOTE
Make sure that battery voltage is 12 V or
more.
1) Make a mark (1) on rear wiper motor (2) stop
position as shown.
2) Check rear wiper motor for operation as follows.
• For motor operation
a. Connect battery positive terminal to terminal
"1" and its negative terminal to terminal "2".
b. Check motor revolution speed as
specification. If check result is not as
specified, replace motor.
Specification
35 – 45 r/min (rpm)
1
2
3
• For automatic stop operation
S7RS0B9406007
a. Connect battery positive (+) terminal to
b. Disconnect terminal "2" from battery negative
c. Observe the motor (4) turns once again then
I4RS0A940018-01
d. Repeat Step a. to c. several times and check
Windshield Wiper and Washer Switch Removal
and Installation
Removal
1) Disconnect negative (–) cable at battery.
2) Remove steering column hole cover (1).
3) Remove steering column covers (2).
Turn steering wheel to access steering column cover
rear end screws (3).
I4RS0A940019-01
1
terminal "1" and its negative (–) terminal to
terminal "2" and let the motor turn.
(–) terminal and let the motor stop.
stops at a specified position as shown.
5. Mark
that the motor stops at the specified position
every time.
If check result is not satisfied, replace motor.
2
I4RS0A940020-01
S7RS0B9406008
3
I4RS0B940007-02