Suzuki Swift Sport 2004 Service & Repair Manual page 529

4) Pass parking brake cable (1) through bracket (3) of
caliper.
5) Hang parking brake cable on lever (2) as follows.
NOTE
Make sure that lever (4) contacts pin (5).
3
1
4
5
6) Install brake pads and caliper referring to "Rear Disc
Brake Pad Removal and Installation".
7) Connect flexible hose (1) with new washers to
caliper (2).
WARNING
!
Make sure that flexible hose is not twisted
when tightening joint bolt. If it is twisted,
reconnect it using care not to twist it.
Tightening torque
Flexible hose joint bolt (a): 23 N·m (2.3 kgf-m,
17.0 lb-ft)
(a)
1
8) Install brake cable clip (1) securely to bracket (2).
2
9) After reassembling brake lines, bleed air from them
referring to "Air Bleeding of Brake System in Section
4A".
I6RS0C430010-01
10) Check to make sure that system is free from fluid
leakage.
11) Start engine and then depress brake pedal with
about 300 N (30 kg, 66 lbs) load 3 times or more so
as to obtain proper disc to pad clearance.
12) Check to make sure that parking brake lever stroke
is as specified. Refer to "Parking Brake Inspection
and Adjustment in Section 4D".
13) Tighten wheel nuts to specified torque.
Tightening torque
Wheel bolt: 85 N·m (8.5 kgf-m, 61.5 lb-ft)
14) Remove vehicle from hoist and perform brake test
(foot brake and parking brake).
2
I6RS0C430011-01
Rear Brakes:
2
1
I6RS0C430012-01
4C-5