Parking Brake Cable Removal And Installation; Parking Brake Lever Removal And Installation - Suzuki Swift Sport 2004 Service & Repair Manual

4D-3 Parking Brake:
6) Release parking brake lever and then make sure
that there is no drag in rear wheel.
If there is, repeats go to step 2).
7) Make sure that the number of notch is between 4
and 9 when operating parking brake lever.
8) If the number of notch is not between 4 and 9,
replace parking brake cable and/or inspect rear
brake caliper.
Parking brake stroke
When lever is pulled up at 200 N (20kg, 44lbs) : 4
to 9 notches

Parking Brake Cable Removal and Installation

Removal
NOTE
When it is necessary to remove both right
and left parking brake cables, repeat below
steps 2) and 5) on right and left wheels.
1) Hoist vehicle.
2) Remove wheel.
3) Disconnect parking brake cable from equalizer
(parking brake lever) and clamps.
4) Disconnect parking brake cable from lever referring
to "Rear Disc Brake Caliper Removal and Installation
in Section 4C".
5) Remove parking brake cable and parking cable
bracket.
Installation
Install it by reversing removal procedure, noting the
following points.
• Install clamps properly referring to "Parking Brake
Cable Construction".
• Tighten bolts and nuts to specified torque referring to
"Parking Brake Cable Construction".
Tightening torque
Parking brake lever bolt: 25 N·m (2.5 kgf-m, 18.0
lb-ft)
Parking cable clamp bolt: 11 N·m (1.1 kgf-m, 8.0
lb-ft)
Parking cable bracket bolt: 25 N·m (2.5 kgf-m,
18.0 lb-ft)
• Adjust parking brake cable. Refer to "Parking Brake
Inspection and Adjustment".
• Check brake disc for dragging and brake system for
proper performance. Brake test should be performed.

Parking Brake Lever Removal and Installation

Removal
1) Remove console box.
2) Block vehicle wheels and release parking brake
lever.
3) Disconnect lead wire of parking brake switch at
coupler.
4) Loosen parking brake cable adjusting nut (1).
S7RS0B4406002
5) Remove parking brake lever bolts (1) and then
remove parking brake lever assembly (2) with
equalizer (3).
NOTE
Don't disassemble parking brake lever
switch. It must be removed and installed as a
complete switch assembly.
S7RS0B4406003
I4RS0A440004-01
I4RS0A440005-01