Bcm (Included In Junction Block Assembly); Removal And Installation; Outside Air Temperature Sensor Removal And Installation; Outside Air Temperature Sensor Inspection - Suzuki Swift Sport 2004 Service & Repair Manual

10B-39 Body Electrical Control System:

BCM (Included in Junction Block Assembly)

Removal and Installation

CAUTION
!
Do not attempt removal of BCM from junction
block assembly as it may cause contact
failure.
If there is faulty condition in BCM, replace
junction block assembly.
Removal
1) Disconnect negative (–) cable from battery.
2) Disable air bag system referring to "Disabling Air
Bag System in Section 8B".
3) Remove dash side trim (1) and steering column hole
cover (2).
4) Remove junction block assembly mounting nuts (3).
4. BCM 5. Junction block assembly
5) Disconnect connectors from BCM and junction block
assembly.
6) Detach wiring harness clamp from junction block
assembly.
Installation
Reverse removal procedure for installation, noting
following points.
• Connect connectors securely.
• Enable air bag system referring to "Enabling Air Bag
System in Section 8B".
Outside Air Temperature Sensor Removal and
Installation
For removal and installation, refer to "Outside Air
Temperature Sensor Removal and Installation (If
Equipped) in Section 9C".
Repair Instructions

Outside Air Temperature Sensor Inspection

For inspection, refer to "Outside Air Temperature Sensor
S7RS0BA206001
Inspection (If Equipped) in Section 9C".
Security Alarm Mode Selection Procedure (If
Equipped)
Security alarm mode can be selected by performing the
following procedure.
1) Confirm that all doors are closed, all doors are
unlocked and ignition key is inserted in ignition key
cylinder.
2) Remove ignition key from ignition key cylinder.
3) Perform Step a) through e) described below within
15 seconds.
a) Insert ignition key (1) in ignition key cylinder (2).
b) Remove ignition key from ignition key cylinder.
c) Repeat Step a) and b) twice.
d) Insert ignition key in ignition key cylinder.
e) Push lock side (3) of driver side manual lock
switch (4) 3 times.
I4RS0BA20010-01
4) When Step 3) is completed, the mode changes to
the next one automatically. The warning buzzer
(located in BCM) sounds by the number of specified
for each mode as follows.
• Changed from A mode to B mode: Buzzer sounds
4 times
• Changed from B mode to A mode: Buzzer sounds
once
S7RS0BA206002
S7RS0BA206003
S7RS0BA206004
2
1
3
4
I5RS0DA20007-01