Driver Air Bag (Inflator) Module Inspection; Passenger Air Bag (Inflator) Module Removal And Installation - Suzuki Swift Sport 2004 Service & Repair Manual

Driver Air Bag (Inflator) Module Inspection

WARNING
!
Never disassemble air bag (inflator) module
or measure its resistance. Otherwise,
personal injury may result.
CAUTION
!
If air bag (inflator) module was dropped from
a height of 90 cm (3 ft) or more, it should be
replaced.
Check air bag (inflator) module visually and if any of the
following is found, replace it with a new one.
• Air bag being deployed
• Trim cover (pad surface) (1) being cracked
• Inflator case (2) being damaged or having been
exposed to strong impact (dropped)
• Bend or deformity of air bag (inflator) module bracket.
Passenger Air Bag (Inflator) Module Removal
and Installation
WARNING
!
• Never attempt to disassemble or repair the
passenger air bag (inflator) module. If any
abnormality is found, be sure to replace it
with new one as an assembly.
• Be sure to read "Precautions on Service
and Diagnosis of Air Bag System",
"Precautions on Handling and Storage of
Air Bag System Components" and
"Precautions on Disposal of Air Bag and
Seat Belt Pretensioner" before starting to
work and observe every precaution during
work. Neglecting them may result in
personal injury or undeployment of the air
bag when necessary.
S7RS0B8206006
1
2
I4RS0A820059-01
S7RS0B8206007
Removal
1) Disable air bag system. Refer to "Disabling Air Bag
System".
2) Disconnect passenger air bag (inflator) module
connector (1) as shown in figure.
a) Unlock lock button (2).
b) With lock button unlocked, disconnect connector.
3) Remove passenger air bag (inflator) module
attaching bolts (1).
4) Remove passenger air bag (inflator) module with air
bag hole cover (1) from instrument panel as shown.
1
"A" "A"
"A"
Air Bag System: 8B-103
1
a)
2
b)
I4RS0A820060-01
1
I4RS0A820061-01
I4RS0A820062-01