Rear Wheel Speed Sensor Inspection - Suzuki Swift Sport 2004 Service & Repair Manual

4F-60 Electronic Stability Program:
4) Hoist vehicle and remove wheel.
5) Remove harness clamp (1) and clamp bolts (2).
6) Remove rear wheel speed sensor (3) from knuckle.
Installation
CAUTION
!
Do not pull or twist wire harness more than
necessary when installing rear wheel speed
sensor.
Reverse removal procedure for installation noting the
following.
• Check that no foreign material is attached to
sensor(1) and mating encoder (2).
• Be sure to install wheel speed sensor (1) and its bolt
at the correct position as shown in figure.
Tighten sensor bolt and harness clamp bolts to
specified torque.
Tightening torque
Rear wheel speed sensor bolt (a): 11 N·m (1.1 kgf-
m, 8.0 lb-ft)
Rear wheel speed sensor harness clamp bolt (a):
11 N·m (1.1 kgf-m, 8.0 lb-ft)
• Check that there is no clearance between sensor and
brake back plate.
1
2
3
I6RS0B460036-02
[A]
1
[A]: OK

Rear Wheel Speed Sensor Inspection

Refer to "Front Wheel Speed Sensor Inspection" since
rear wheel speed sensor is the same as front wheel
speed sensor.
(b)
(a)
1
2
[B]
1
I6RS0B460037-02
[B]: NG
S7RS0B4606032