Front Seat Belt Removal And Installation; Front Seat Belt Inspection - Suzuki Swift Sport 2004 Service & Repair Manual

Front Seat Belt Removal and Installation

WARNING
!
• Never attempt to disassemble or repair the
seat belt pretensioner (retractor
assembly). If any abnormality is found, be
sure to replace it with new one as an
assembly.
• Be sure to read "Precautions on Service
and Diagnosis of Seat Belt" before starting
to work and observe every precaution
during work. Neglecting them may result in
personal injury or unactivation of the seat
belt pretensioner when necessary.
Removal
1) Disconnect negative (–) cable at battery.
2) Disable air bag system. Refer to "Disabling Air Bag
System in Section 8B".
3) Remove center pillar lower trim.
4) Disconnect Yellow connector (1) from seat belt
pretensioner (2).
a) Release locking of lock button (3).
b) After unlocked, disconnect to connector.
2 1
5) Remove front seat belts from the vehicle.
Installation
Install in reverse order of removal, noting the following.
• Seat belt anchor bolts should have an unified fine
thread (7/16-20 UNF). Under no circumstances
should any different sized or metric screw threads be
used.
• Connect Yellow connector (1) to seat belt
pretensioner securely.
a. Connect connector.
b. Lock connector with lock slider (2).
S7RS0B8106002
3
a
b
I6RS0B810003-01
b)
1
• Enable air bag system. Refer to "Enabling Air Bag
System in Section 8B".

Front Seat Belt Inspection

WARNING
!
• Never attempt to disassemble or repair the
seat belt pretensioner (retractor
assembly). If any abnormality is found, be
sure to replace it with new one as an
assembly.
• Be sure to read "Precautions on Service
and Diagnosis of Seat Belt", before
starting to work and observe every
precaution during work. Neglecting them
may result in personal injury or
unactivation of the seat belt pretensioner
when necessary.
• Never measure resistance of pretensioner
or disassemble it. Otherwise, personal
injury may result.
CAUTION
!
If seat belt pretensioner (retractor assembly)
was dropped from a height of 30 cm (1 ft) or
more, it should be replaced.
Seat belts and attaching parts can affect the vital
components and systems of a vehicle.
Therefore, they should be inspected carefully and
replaced with genuine parts only.
Seat Belts:
a)
1
2
I6RS0B810004-01
S7RS0B8106003
I2RH01810004-01
8A-4