Suzuki Swift Sport 2004 Service & Repair Manual page 776

5A-132 Automatic Transmission/Transaxle:
• Measure forward clutch piston stroke in the same
manner as "Forward and Reverse Clutch Assembly
Preliminary Check".
When piston stroke is out of specification, select
forward clutch retaining plate with proper thickness
from among the following table and replace it.
Special tool
(A): 09900–20607
(B): 09900–20701
(C): 09952–06020
Forward clutch piston stroke
1.30 – 1.50 mm (0.051 – 0.059 in.)
Available forward clutch retaining plate thickness
Thickness
3.0 mm (0.118 in.)
3.1 mm (0.122 in.)
3.2 mm (0.126 in.)
3.3 mm (0.130 in.)
3.4 mm (0.134 in.)
3.5 mm (0.138 in.)
3.6 mm (0.142 in.)
1. Oil hole
• Install reverse clutch cushion plate (1) in correct
direction as shown in figure.
• Apply A/T fluid to reverse clutch cushion plate (1),
reverse clutch separator plate (2), discs (3) and
retaining plate (4).
• Install reverse clutch cushion plate (1), reverse clutch
separator plate (2), discs (3), retaining plate (4) and
then snap ring (5) to intermediate shaft subassembly.
Identification mark
1
5
2
6
3
7
4
I2RH0B510177-02
I3RM0B510062-01
• Install reverse clutch plate snap ring so that its both
ends would be positioned in correct locations as
shown in figure.
[A]: Correct
• Measure reverse clutch piston stroke in the same
manner as "Forward and Reverse Clutch Assembly
Preliminary Check".
When piston stroke is out of specification, select
reverse clutch retaining plate with proper thickness
from among the following table and replace it.
Special tool
(A): 09900–20607
(B): 09900–20701
Reverse clutch piston stroke
1.20 – 1.60 mm (0.047 – 0.063 in.)
Available reverse clutch retaining plate thickness
Thickness
3.0 mm (0.118 in.)
3.2 mm (0.126 in.)
3.4 mm (0.134 in.)
3.6 mm (0.142 in.)
I2RH0B510190-01
[B]: Incorrect
Identification mark
1
2
3
4
I2RH0B510191-01