Immobilizer Indicator Lamp Remains On After Engine Starts - Suzuki Swift Sport 2004 Service & Repair Manual

Step
4 Fuse check
1) Turn ignition switch to OFF position.
2) Check for fuse blown at combination meter circuit fuse in
junction block assembly.
Is fuse in good condition?
5 CAN communication circuit check
1) Disconnect connectors of all control modules
communicating by means of CAN.
2) Check CAN communication circuit between control
modules for open, short and high resistance.
Is each CAN communication circuit in good condition?
6 Combination meter power and ground circuit check
1) Remove combination meter referring to "Combination
Meter Removal and Installation in Section 9C".
2) Check for proper connection to combination meter
connector terminals.
3) If OK, then turn ignition switch to ON position, Check
terminal voltage of combination meter between power
supply and ground terminal. Refer to "Combination
Meter Circuit Diagram in Section 9C".
Is it 10 – 14 V?

Immobilizer Indicator Lamp Remains ON after Engine Starts

Wiring Diagram
Refer to "Immobilizer Control System Wiring Circuit Diagram".
Circuit Description
When the ignition switch is turned ON, ECM read the code by the coil antenna from ignition key. Then if the code in
transponder in the key match with the one registered with ECM, transmits indication ON signal of immobilizer indicator
lamp to combination meter in order to turn immobilizer indicator lamp on. And then, combination meter turns
immobilizer indicator lamp on. When the engine starts to run and no malfunction is detected in the system, ECM
transmits immobilizer indicator lamp indication OFF signal to combination meter in order to turn immobilizer indicator
lamp off. And then, combination meter turns immobilizer indicator lamp off, but if a malfunction was or is detected,
immobilizer indicator lamp is flashes ON and OFF, when ignition switch turn to ON position.
Troubleshooting
Step
1 DTC check of ECM
1) Start engine and recheck DTC of ECM while engine
running.
Is DTC P1674, P1675, P1678 and/or P1685 detected?
2 CAN communication circuit check
1) Disconnect connectors from ECM, BCM, ABS control
module and combination meter.
2) Check CAN communication circuit for open, short and
high resistance.
• Between ECM and ABS control module
• Between BCM and ABS control module
• Between BCM and combination meter
Is each CAN communication circuit in good condition?
Action
Action
Immobilizer Control System:
Yes
Go to Step 5.
Go to Step 6.
Substitute a known-
good combination meter
and recheck. If
immobilizer indicator
lamp still remains OFF,
substitute a known good
ECM and recheck.
Yes
Go to applicable DTC
diag. flow.
Substitute a known-
good combination meter
and recheck. If
immobilizer indicator
lamp still remains ON,
substitute a known-
good ECM and recheck.
10C-8
No
Replace fuse and check
for short to power or
ground circuit.
Repair circuit.
Repair power supply
and/or ground circuit.
S7RS0BA304007
No
Go to Step 2.
Repair circuit.