Dtc B1013: Sdm Fault; Dtc B1014: "Air Bag" Warning Right Circuit Failure - Suzuki Swift Sport 2004 Service & Repair Manual

CAUTION
!
• Be sure to perform "Air Bag Diagnostic System Check" before starting diagnosis according to flow.
• When measurement of resistance or voltage is required in this flow, use a tester along with a correct
terminal adapter from special tool (Connector test adapter kit).
• When a check for proper connection is required, refer to "Inspection of Intermittent and Poor
Connections".
• If there is open circuit in the air bag wire harness, connector or terminal is found damaged, replace
the wire harness, connector and terminal as an assembly.
Flow Test Description
Check for short circuit between diagnosis switch circuit and ground.
Troubleshooting
Step
1 1) With ignition switch OFF, disconnect SDM connector
"L29".
2) Check "L29-35" terminal of SDM.
Is it shorted to ground terminal or harness?
NOTE
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components and ensure all components are properly mounted.
• Repeat "Air Bag Diagnostic System Check" to confirm that the trouble has been corrected.

DTC B1013: SDM fault

DTC Will Set when
An internal SDM fault is detected by SDM.
NOTE
DTC B1013 can never be cleared once it has been set.
DTC Troubleshooting
1) Turn ignition switch OFF.
2) Replace SDM.
3) Repeat "Air Bag Diagnostic System Check".

DTC B1014: "AIR BAG" Warning Right Circuit Failure

Wiring Diagram
1
1. From main fuse
2. Ignition switch
3. "METER" fuse
Action
"G28"
RED/BLK
"G33"
3
4
GRN
2
"G32"
4. "A/BAG" fuse
5. "AIR BAG" warning right in combination meter
6. Lamp driver
Clean up terminal.
6
5
YEL/BLK
"G34"
"L04"
YEL/BLK
7
RED
BLK
9
Air Bag System:
Yes
Substitute a know-good
SDM and recheck.
"L29"
8
L29-2 WL
L29-27 IG
L29-28
E1
7. Junction block assembly
8. SDM
9. Ground for air bag system
8B-17
No
S7RS0B8204010
S7RS0B8204011
I7RS0B820004-04