Sdm Removal And Installation - Suzuki Swift Sport 2004 Service & Repair Manual

8B-100 Air Bag System:
6) If equipped with side curtain-air bag (inflator)
module, connect black connector (1) securely as
shown in figure.
a) Connect connector.
b) Lock connector with lock button (2).
1
7) Install "A/BAG" fuse to fuse box.
8) Connect negative (–) cable at battery.
9) Turn ignition switch to ON position and verify that
"AIR BAG" warning right flashes 6 times and then
turns OFF. If it does not operate as described,
perform "Air Bag Diagnostic System Check".
b)
2
a)
I4RS0A820055-01

SDM Removal and Installation

WARNING
!
During service procedures, be very careful
when handling a Sensing and Diagnostic
Module (SDM).
Be sure to read "Precautions on Service and
Diagnosis of Air Bag System" before starting
to work and observe every precaution during
work. Neglecting them may result in personal
injury or inactivation of the air bag system
when necessary.
Removal
1) Disconnect negative cable at battery.
2) Disable air bag system referring to "Disabling Air
Bag System".
3) Remove center console box referring to "Console
Box Components in Section 9H".
4) Disconnect SDM connector (1) from SDM (2).
5) Remove SDM (2) from vehicle.
A
A: Forward
S7RS0B8206003
2
1
I4RS0A820056-01