Suzuki Swift Sport 2004 Service & Repair Manual page 809

81) After applying A/T fluid to new O-ring, fit it to fluid
filler tube. Then install fluid filler tube to transaxle
case.
Tightening torque
Fluid filler tube bolt (d): 10 N·m (1.0 kgf-m, 7.5
lb-ft)
(d)
(c)
82) Apply A/T fluid to O-rings of each sensor and install
input shaft speed sensor (1) and output shaft speed
sensor (2).
Tightening torque
Input shaft speed sensor bolt (a): 11 N·m (1.1
kgf-m, 8.0 lb-ft)
Output shaft speed sensor bolt (b): 13 N·m (1.3
kgf-m, 9.5 lb-ft)
83) Install harness bracket (3) and select cable clamp
(4).
Tightening torque
Harness bracket bolt (c): 23 N·m (2.3 kgf-m, 17.0
lb-ft)
Select cable clamp bolt (d): 10 N·m (1.0 kgf-m,
7.5 lb-ft)
84) Install transmission range sensor to transaxle case,
(b)
2
1,(a)
85) Install lock washer (1) and tighten lock nut (2) to
(b)
2
I3RM0B510070-01
86) Install manual select lever (1) temporarily at this
87) After shifting manual select lever counterclockwise
88) Remove manual select lever (1) at this step.
89) Loosen sensor bolts (4) and align needle direction
90) Tighten sensor bolts to specified torque.
I3RM0B510071-01
Automatic Transmission/Transaxle:
tighten bolts temporarily at this step.
specified torque.
Tightening torque
Transmission range sensor lock nut (a): 7 N·m (
0.7 kgf-m, 5.0 lb-ft)
step.
fully, select "N" range position by bringing it back 2
notches clockwise.
shaped on lock washer (2) with "N" reference line (3)
on transmission range sensor by moving sensor in
rotative direction.
Tightening torque
Transmission range sensor bolt (b): 5.5 N·m (
0.55 kgf-m, 4.0 lb-ft)
5A-165
I3RM0B510072-01
I3RM0B510073-01
I3RM0B510074-01