Suzuki Swift Sport 2004 Service & Repair Manual page 1103

CAUTION
!
• Be sure to perform "Air Bag Diagnostic System Check" before starting diagnosis according to flow.
• When measurement of resistance or voltage is required in this flow, use a tester along with a correct
terminal adapter from special tool (Connector test adapter kit).
• When a check for proper connection is required, refer to "Inspection of Intermittent and Poor
Connections".
• If there is open circuit in the air bag wire harness, connector or terminal is found damaged, replace
the wire harness, connector and terminal as an assembly.
DTC Will Set when
The combined resistance of the side-air bag (inflator) module (driver or passenger), harness wiring and connector
terminal contact is above a specified value for specified time.
Flow Test Description
Step 1: Check whether malfunction is in side-air bag (inflator) module.
Step 2: Check side-air bag initiator circuit in floor harness.
Step 3: Check side-air bag initiator circuit in seat harness.
DTC Troubleshooting
Step
1 1) With ignition switch OFF, disconnect side-air bag
(inflator) module connector under front seat cushion.
2) Check proper connection to driver or passenger side-air
bag (inflator) module at terminals in "L25" or "L30"
connector.
3) If OK, then connect special tools (B) and (C) to side-air
bag (inflator) module connector disconnected at the Step
1).
Special tool
(B): 09932–75010
(C): 09932–78340
STEERING WHEEL
4) Check SDM DTC.
With ignition switch ON, is DTC B1061 or B1065 still
indicated?
Action
"L25", "L30"
(C)
(B)
I4RS0A820032-01
Air Bag System:
Yes
Go to Step 2.
8B-65
No
Go to Step 3.