Center Shaft And Center Bearing Support Disassembly And Reassembly - Suzuki Swift Sport 2004 Service & Repair Manual

3A-14 Drive Shaft / Axle:
Center Shaft and Center Bearing Support
Disassembly and Reassembly
Disassembly
1) Remove snap ring and O-ring (M/T model) from
center shaft.
2) Using hydraulic press (1), draw out center shaft (2)
from center bearing.
3) Remove center bearing from bearing support as
follows.
A/T model
a) Remove oil seals from center bearing support
(3).
b) Remove bearing support circlip (1) using snap
ring pliers (2) and then remove center bearing
from center bearing support.
M/T model
a) Remove bearing support circlip (1) using snap
ring pliers (2) and then remove center bearing
from center bearing support.
Reassembly
Assemble center shaft by reversing disassembly
procedure and noting the following points.
• When installing bearing support circlip (1), make sure
that if fits in circlip groove in center bearing support (2)
securely as shown.
S7RS0B3106005
• For A/T model, when installing left oil seal (1) and right
oil seal (2) using special tool, use care so that oil seals
in proper direction and position as shown in figure.
Special tool
: 09925–15410
Distance
"a": 7 – 8 mm (0.28 – 0.31 in.)
"b": 0 – 1 mm (0 – 0.04 in.)
• For A/T model, be sure to apply grease to oil seal lip
I3RM0A310012-01
and bearing side space indicated in figure.
"A": Grease 99000–25011 (SUZUKI Super Grease
A)
• Press-fit center shaft (1) from left oil seal (2) or circlip
(3) side.
I6RS0B310006-03
• For M/T model, apply grease to O-ring and then install
O-ring to center shaft.
[A]: A/T model [B]: M/T model
1
"A"
"a"
[A]: A/T model [B]: M/T model
I6RS0C310007-01
2
"A"
"b"
I4RS0A310014-01
I6RS0C310008-02