Actuator Linkage Inspection; Blower Motor Controller Removal And Installation; Blower Motor Controller Inspection - Suzuki Swift Sport 2004 Service & Repair Manual

7B-76 Air Conditioning System: Automatic Type

Actuator Linkage Inspection

• Check if each actuator linkage operates smoothly.
• Check actuator rod for bend.
• Check each actuator linkage for breakage.
• Make sure if there is not any obstruction in operating
range of actuator linkage.
If any malfunction is found, repair or replace faulty
part(s).
Blower Motor Controller Removal and
Installation
Refer to "Blower Motor Resistor Removal and
Installation in Section 7A".

Blower Motor Controller Inspection

S7RS0B7226010
1) Check internal circuit of controller for resistance as
follows.
a) Measure resistance between "1" terminal and "2"
terminal of blower motor controller.
Blower motor controller resistance
"1" – "2": approximately 10 kΩ at 25°C (77°F)
If resistance does not meet above specification,
replace blower motor controller.
b) Using ohmmeter, connect its positive terminal to
"3" terminal of blower motor controller and
S7RS0B7226011
negative terminal to "1" terminal of blower motor
controller and check that there is no continuity.
2) Check controller for operation as follows.
a) Using service wire, connect battery positive
terminal to "3" terminal of blower motor controller
and battery negative terminal to "1" terminal of
blower motor controller.
b) Using bulb (3.4 W) (5) and service wire, connect
battery positive terminal to "3" terminal of blower
motor controller as shown figure.
c) Arrange 3 new 1.5 V batteries (6) in series
(check that total voltage is 4.5 – 5.0 V) and
connect its positive terminal to "2" terminal of
blower motor controller and negative terminal to
"1" terminal of blower motor controller.
Then, check that bulb lights. If bulb does not light
under the above conditions, replace blower
motor controller.
2
1
4
3
3
4
2
1
6
S7RS0B7226012
5
I5RS0A722026-01