Dtc Check - Suzuki Swift Sport 2004 Service & Repair Manual

8B-12 Air Bag System:
DTC
B1081
B1082
Driver side-
B1083
sensor
B1084
B1085
B1091
B1092
Passenger
B1093
side-sensor
B1094
B1095
B1361
Driver side
B1362
curtain-air
B1363
bag circuit
B1364
B1365
Passenger
B1366 side curtain-
B1367 air bag
circuit
B1368

DTC Check

1) Turn ignition switch to OFF position.
2) Connect SUZUKI scan tool to data link connector
(DLC) located on underside of instrument panel at
driver's seat side.
Special tool
(A): SUZUKI scan tool
3) Turn ignition switch to ON position.
4) Read DTC according to instructions displayed on
SUZUKI scan tool and print it or write it down. Refer
to SUZUKI scan tool operator's manual for further
details.
If communication between scan tool and SDM is not
possible, check if scan tool is communicable by
connecting it to SDM in another vehicle. If
communication is possible in this case, scan tool is
in good condition. Then check data link connector
and serial data line (circuit) in the vehicle with which
communication was not possible.
Diagnosis
Performance Diagnose
problem trouble
Communicatio according to
n error diagnostic flow
Short to ground corresponding
Short to power to each code
circuit or open No.
Wrong
assembly
Performance
problem
Communicatio
n error
Short to ground
Short to power
circuit or open
Wrong
assembly
Resistance
high
Resistance low
Short to ground
Short to power
circuit
Resistance
high
Resistance low
Short to ground
Short to power
circuit
S7RS0B8204004
5) After completing the check, turn ignition switch to
OFF position and disconnect SUZUKI scan tool from
data link connector (DLC) (1).
1
DTC Clearance
1) Turn ignition switch to OFF position.
2) Connect SUZUKI scan tool to data link connector
(DLC) (1) in the same manner as when making this
connection for DTC check.
Special tool
(A): SUZUKI scan tool
1
3) Turn ignition switch to ON position.
4) Erase DTC according to instructions displayed on
SUZUKI scan tool. Refer to SUZUKI scan tool
operator's manual for further details.
5) After completing the clearance, perform "DTC
Check" and confirm that normal DTC (NO CODES)
is displayed and not malfunction DTC.
6) Turn ignition switch to OFF position and disconnect
SUZUKI scan tool from DLC.
NOTE
If DTC B1013, DTC B1021 or DTC B1027 is
stored in SDM, it is not possible to clear DTC.
(A)
I4RS0A820008-01
S7RS0B8204005
(A)
I4RS0A820008-01