Mobility Plate Information; Electrical Requirements; Audible Noise; Installation Considerations - Xerox Work Centre 7970i Customer Expectation & Installation Manual

Installation

Mobility Plate Information

Carpeted flooring surfaces may require the installation of a mobility
plate on the IOT and Finishers to allow the product to be moved during
normal maintenance activities.

Electrical Requirements

*Please refer to detailed specifications section on page 4
Ground Fault Protection is provided which meets Xerox internal safety
requirements and exceeds the Industry Standards for Information
Technology Equipment.

Audible Noise

Sound Power Operating: 7.6 LwAd (B)
Levels Standby: 3.5 LwAd (B)
Engine
Sound Pressure Operating: 58 LpAd (dBA)
Levels Standby: 17 LpAd (dBA)
Audible Noise
7970/7970i Full System
(Finisher/Folder/HCF)
Sound Power Operating: 7.82 LwAd (B)
Levels Standby: 4.45 LwAd (B)
Sound Pressure Operating: 65.7 LpAd (dBA)
Levels Standby: 26.7 LpAd (dBA)

Installation Considerations


There should be a minimum of 78 inches (1,981 mm) clearance
from the floor to the nearest overhead obstruction.
Customer Expectation and Installation Guide
7970/7970i Base Engine

The Base Configuration unit weighs about 334.2 lbs(151.9 Kg)

Electrical requirements and space requirements must be
satisfied before the equipment is delivered.

One network drop is required for installation.

Network Requirements


The customer is responsible for connecting and configuring the
equipment on their network.

One network drop is required for installation.

Fax Telephone Line Requirements (Optional)

If the fax option is installed, the following telephone line requirements
are applicable:
Telephone wall jack should be within 7' of the middle left side of the
back of the unit.
1. Telephone Service Supported:

Sole-use, non-switchboard (direct dial)

RJ11 – 6 position, 4 pin modular jack

Single analog line.
2. For two line fax, a second telephone line meeting the
requirements identified in items 1 and 2 above is required.
3. Fax over VOIP is not supported

Convenience Stapler (Optional)

Requires separate outlet from one required for device. Refer to the
above product electrical requirements for outlet type and requirements.
The same electrical line as the device may be used; if no other devices
are present on the line.

Energy Star

Energy Star is a government-backed program helping businesses and
individuals protect the environment through superior energy efficiency.
The WorkCentre 7970/7970i is Energy Star certified.
The WorkCentre automatically switches to a Low Power mode after an
idle period. After an additional idle period, the machine switches to
sleep mode, saving additional power. The customer can adjust the
"Time to Low Power mode" and the "Time to Sleep Mode" as described
in the documentation.
®
WorkCentre 7970 Series
19