Installing Optional Expansion Boards; Installing I/O Expansion Boards - Sony DFS-900M Operating Instructions Manual

Installing Optional Expansion Boards

Installing I/O Expansion Boards

About installation locations and channel numbers
38
Installing Optional Expansion Boards
This section explains how to install I/O expansion boards, function expansion
boards, and the optional power supply unit.
The following expansion options are available. For more information about the
various options, see page 30.
Type and function of expansion options
Input expansion 4 SDI Input Board
boards
2 SD Video Input Board
2 DVI Input Board
Output expansion 4 SDI Output Board
boards
2 SD Video Output
Board
2 DVI Output Board
Function expansion 2CH DME Board
boards
Multi Viewer Board
Power supply unit
Notes
• Always power off all devices before starting the operation for installing or
removing expansion options.
• The processor unit will still be hot immediately after it is powered off.
Always wait at least 30 minutes before starting the operation for
installing or removing expansion options.
• Always install expansion options in the designated locations.
• Always install expansion options using the screws supplied with the
expansion options. Use of other screws may damage the expansion options or
processor unit.
• Be careful to avoid injury when installing and removing expansion options.
• You can use the Status sub menu of the Setup menu to check whether
expansion options are installed. For details, see page 169.
Pull out the expansion board installation trays from the I/O expansion board
slots (lower and upper) on the rear panel of the processor unit, use the screws
supplied with the boards to secure them to trays, and then return the trays to the
slots. Facing the processor unit, install the input expansion boards at the far left
and center positions, and install the output expansion boards at the far right
position.
Model number
BKDF-910
BKDF-911
BKDF-912
BKDF-960
BKDF-961
BKDF-962
BKDF-940
BKDF-950
BKDF-990