Table of Contents
Advertisement
Specifying the signal type of analog input signals
82
Basic Switcher Settings
5
Rotate the F3 knob to select the conversion mode.
4:3: Input with 4:3 aspect ratio (add black to left and right sides of picture)
4:3BGS: Input with 4:3 aspect ratio (Add still images to the left and right
sides of picture. The two sides of a downloaded still image file (HDTV
size) are added to the video input.)
SQ: Input as squeeze video
LB: Input as letterbox video
Off: Do not up-convert
Notes
• For information about how to download still images from still image
storage memory to the memory of switcher inputs, see page 117.
• When you select 4:3BGS, download an HDTV size still image. The left
and right sides of the picture will not be displayed normally if no image is
downloaded or if the downloaded image is a SDTV size image.
When you are using the optional BKDF-911 2 SD Video Input Board, specify
the signal type of the analog signals that will be input to the board.
For more information about the BKDF-911, see page 30. For information about
how to install it, see page 38.
Note
Regardless of this setting, the only signals that can be input to the COMP
connector of the BKDF-911 are SD analog composite signals.
BKDF-902
1
When using the BKDF-901: If the SHIFT button in the DME/SETUP
block is not lit, press it to light it.
When using the BKDF-902: Skip to step 2.
2
Press the INPUT button.
BKDF-901
Advertisement
Table of Contents
