Table of Contents
Advertisement
Message
Display panel
File read error
Gray scale loaded
Include Wrong DME No
No assignable DME
No free memory
No KeyFrame
No more KeyFrames
No Option
No specified SEQ
No specified Still
No system-data file
No update file
No USB Device USB
No User Pattern
198
Messages and Actions to Take
GUI menu screen
Gray scale file loaded
No more KeyFrames
available
No specified SEQ file
No specified Still file
No specified update file
Description
Appears in the following cases.
a) Loading of the file failed during
a still image file download.
b) Loading of the signal name data
failed when display of multi-view
signal names is on.
Appears when an 8-bit gray scale
still image file is loaded.
Appears when you attempt to
recall a user pattern, sequence, or
event that uses an effect not
supported by this version.
Backgrounds and keys 1 to 4 are
not recalled if they include effects
not supported by this version.
Appears when an attempt is made
to change a transition type from a
non-DME effect to a DME effect,
even though the maximum number
of DME channels are already in
use.
Appears when the control panel
OS has no free memory.
Appears when an attempt is made
to delete the current keyframe from
a sequence when the target
keyframe does not exist.
Appears when an attempt is made
to register a new keyframe when
the maximum number of
keyframes has already been
registered in a sequence, or when
an attempt is made to change the
current keyframe to higher than the
maximum number of registered
keyframes.
Appears when you switch to the
MV1 or MV2 sub menu with no
BKDF-950 installed.
Appears when the specified
sequence file cannot be found.
Appears when the specified still
image file cannot be found.
Appears when system data file
cannot be found.
Appears when the specified
update file cannot be found.
Appears when no USB flash drive
is connected.
Appears when you recall an event
that uses a wipe or DME user
pattern if the user pattern is not
registered.
Recall an unregistered user
pattern by specifying 0 as pattern
number.
Action to take
a) Try downloading the still image
file again.
b) Reset the settings of the output
video, and try turning the
display of signal names off and
on again.
Select a still image file in another
format.
Save the user pattern, sequence,
or event after modifying it to use
only supported effects, and then
recall it again.
Reduce the number of DME
channels and try the operation
again.
Wait for a while and try the
operation again.
Select another keyframe.
Delete one or more keyframes and
try again.
Install a BKDF-950.
Specify another sequence file.
Select another still image file.
Select the system data and try the
operation again.
Check to make sure that the
specified update file exists on a
USB flash drive connected to the
USB MEMORY connector, and
then try the operation again.
Connect a USB flash drive.
Register the user pattern used by
the event and then recall the event
again.
Advertisement
Table of Contents
