Adding Trail Effects, And Changing The Color Type - Sony DFS-900M Operating Instructions Manual

Softness sub menu parameters
Adjust the following parameters to adjust the softness of
the inner and outer sides of the border.
Operation Knob
Adjust the F1
softness of the
inner side of the
border.
Adjust the F2
softness of the
outer side of the
border.
Bevel Color sub menu parameters
Beveled edges make a border appear three dimensional.
Adjust the following parameters to select whether to add
beveled edges to an image, and to adjust the color of the
beveled edges, if added. (This effect is not available in this
version.)
Note
It is not possible to adjust the widths of left, right, top, and
bottom beveled edges independently.
Beveled edge example
For information about how to adjust beveled edge widths,
see "Inner Width sub menu parameters" (page 137) and
"Outer Width sub menu parameters" (page 137).
Operation Knob Parameter
Select whether F1
to add beveled
edges to an
image.
Adjust the F2
luminance of the
beveled edges.
Adjust the F3
saturation (color
density) of the
beveled edges.
Adjust the hue of F4
the beveled
edges.
138
Customizing DME Effects
Parameter Settings
InS (Inner 0 to15
Softness)
OutS (Outer 0 to15
Softness)
Beveled edge
Settings
On: Add
Bvl (Beveled
Off: Do not
Enable)
add
Lum (Luminance) 0.0 to 108.6
Sat (Saturation) 0.0 to 100
Hue 0.0 to 359.5
Border HL (Highlight Setup) sub menu
parameters
Adjust the following parameters to specify the direction
and brightness of the light source that illuminates beveled
edges. (This effect is not available in this version.)
Beveled edge
Lowlight
part
Beveled edge example
Operation Knob Parameter
Set the direction of F1
the light source.
(Specify as a
position
corresponding to a
number on the face
of an analog clock.)
Example: 3
corresponds to the
direction from 3
o'clock.
Set the mixture ratio F2
of the highlight
(lighter) part and the
border color.
Set the mixture ratio F3
of the lowlight
(darker) part and
the border color.
Adding Trail Effects, and Changing
the Color Type
You can adjust the parameters of the Sub Effects sub
menus to add trail effects to images. (Trail effects are not
available in this version.) You can also change the image
color type (chroma control).
Trail effect: Adds trail-like afterimages.
Chroma control: Allows you to change the color type of
images to sepia, black and white, or negative.
Highlight
part
Light
source
direction
Settings
Dir (Hilight 0 to 11
Direction)
HL (Hilight 0 to 100.0
Opacity)
LL (Lowlight 0 to 100.0
Opacity)