Table of Contents
Advertisement
Specifying the signal type of DVI input signals
84
Basic Switcher Settings
Setting
Name of
of step 5
BKDF-911
connector
Y/CB/CR
COMP/Y
B-Y
R-Y
COMP
a) Connector is disabled
6
If you selected Y/CB/CR in step 5, rotate the F4 knob to select the level of
the component input signals.
Betacam: Betacam level
SMPTE: SMPTE level
Note
Settings of step 6 can be available only when the switcher's video format
(see page 70) is set to 525/59, 720/59, or 1080/59.
When you are using the optional BKDF-912 2 DVI Input Board, specify the
picture size and aspect ratio conversion modes for the DVI signals that will be
input to the board.
For more information about the BKDF-912, see page 30. For information about
how to install it, see page 38.
Note
Depending on the video format setting of this switcher (page 70), select the DVI
input signal resolution from the values in the following table. If you specify a
resolution other than the values shown in the table, images may be unable to be
reproduced normally.
Video format setting
525/59 or 625/50
720/50 or 720/59
1080/50 or 1080/59
Input signal BKDF-911 installation position
and channel number
Lower tray
Left
Center
Luminance
IN09
IN13
(Y) signal
Color
difference
(B-Y) signal
Color
difference
(R-Y) signal
Composite
IN10
IN14
signal
DVI input signal resolution
VGA (640 × 480)
SVGA (800 × 600)
XGA (1024 × 768)
XGA (1024 × 768)
SXGA (1280 × 1024)
WXGA (1280 × 768)
XGA (1024 × 768)
SXGA (1280 × 1024)
WXGA (1280 × 768)
UXGA (1600 × 1200)
WSXGA (1680 × 1050)
WUXGA (1920 × 1200)
Upper tray
Left
Center
IN17
IN21
IN18
IN22
Advertisement
Table of Contents
