Table of Contents
Advertisement
Making multi-view output settings
Parameter
Output signal
WXGA
WXGA signal
(1280 x 768)
SXGA
SXGA signal
(1280 x 1024)
UXGA
UXGA signal
(1600 x 1200)
WSXGA
WSXGA signal
(1680 x 1050)
HDTV
Full HDTV size
(1920 x 1080)
signal
WUXGA
WUXGA signal
(1920 x 1200)
a) Only digital signals are output. Analog signals are not output.
Notes
• Depending on the video format setting (see page 70), some parameters
cannot be selected.
• If you select HDTV, color difference component signals (Y/P
output from the analog signal output connectors of the BKDF-962. If you
select another parameter (excluding UXGA and WUXGA), RGB signals
are output.
5
If you selected SXGA or UXGA in step 4, rotate the F3 knob to select the
output mode.
4:3: Cut both sides of the picture and output with aspect ratio 4:3 (edge crop
output).
LB: Output letterbox video.
Note
When 4:3 is selected, the amount cut at the sides of the picture differs
between SXGA and UXGA.
6
Rotate the F4 knob to specify the system format of the output destination.
50Hz: When the system format of the output destination is 50 Hz.
60Hz: When the system format of the output destination is 60 Hz.
Note
50Hz can be selected only when the switcher's video format (see page 70)
is set to 625/50, 720/50, or 1080/50. This setting affects only digital signals
output from the BKDF-962.
The multi-view function is available when you install the optional BKDF-950
Multi Viewer Board in the processor unit. By assigning multi-view output to an
AUX connector and connecting a video monitor, you can check video on a
monitor screen divided into up to 16 partitions, including input video, program
output video, and preview video.
Video format setting
Yes: Can be selected
No: Cannot be selected
(the parameter does not appear)
525/59 or
720/50 or
625/50
720/59
No
Yes
No
Yes
No
No
No
No
No
No
No
No
Basic Switcher Settings
1080/50 or
1080/59
No
Yes
a)
Yes
Yes
Yes
a)
Yes
/P
) are
b
r
95
Advertisement
Table of Contents
