Sequence Operations; Creating Sequences; Recalling Sequences - Sony DFS-900M Operating Instructions Manual

Sequence Operations

You can register a series of video settings as a sequence.
Use the following procedure.

Creating Sequences

Use the following procedure to create a sequence.
BKDF-901
BKDF-902
1
Create the video that you want to register as the first
keyframe in the sequence.
Registering the desired video as an event in advance
may be convenient, because it allows you to restore a
set of video settings to the control panel simply by
recalling the event.
2
Press the SEQ button in the numeric keypad.
The numeric keypad enters sequence mode.
The most recently used sub menu appears in the
display panel.
3
Press the and buttons in the numeric keypad
j J
until the Seq File sub menu appears.
4
Press the NEW button.
Sequence memory is cleared.
5
Press the INSERT button.
The current control panel settings are registered as the
first keyframe of the sequence.
6
Press the SEQ button.
The numeric keypad exits sequence mode.
7
Create the video that you want to register as the next
keyframe.
8
Press the SEQ button again to switch to sequence
mode, and then press the INSERT button.
The video created in step 7 is registered as the next
keyframe.
Repeat steps 6 to 8 to register all of the keyframes that
you want in the sequence.
9
Rotate the F1 knob to select the file in which you want
to save the sequence.
You can select file numbers from 00 to 99.
10
Rotate the F2 knob to select the sequence storage
destination.
You can select either the switcher control panel (CP)
or a USB flash drive.
11
Press the STORE button.
The sequence is stored in the selected file in the
selected storage destination.

Recalling Sequences

Use the following procedure to recall a sequence that you
have created.
155
Sequence Operations