Table of Contents
Advertisement
When using the BKDF-902
1
In the M/E transition block, press the BKGD next
transition selection button, lighting it.
2
Press an M/E bus A selection button in the M/E
cross-point bus block or a PROGRAM bus selection
button in the PROGRAM/PRESET cross-point bus
block to select the video that appears before the cut.
3
Press an M/E bus B selection button in the M/E
cross-point bus block or a PRESET busselection
button in the PROGRAM/PRESET cross-point bus
block to select the video that appears after the cut.
The pressed button lights in green, and the selected
video appears in the preview screen.
4
In the M/E transition block, press the WIPE or DME
transition type selection button, lighting it. Or in the
PROGRAM/PRESET transition block, press the
WIPE transition type selection button, lighting it.
When the WIPE button of the M/E transition block is
pressed, the M/E WIPE menu appears in the display
panel.
M/E WIPE menu
M/E Wipe Pattern
Pat=0 Wid=9.1 Soft=12.5 Src=W.Bd
When the DME button is pressed, the DME menu
appears in the display panel.
DME menu
M/E DME Pattern
Pat=0
When the WIPE button of the PROGRAM/PRESET
transition block is pressed, the P/P WIPE menu
appears in the display panel.
P/P WIPE menu
P/P Wipe Pattern
Pat=0 Wid=9.1 Soft=12.5 Src=W.Bd
Note
DME must be enabled to use DME wipe patterns.
Pressing the DME button when DME is not enabled
has no effect. To enable and disable DME, press the
DME ENABLE button (see page 13) in the KEYER
block.
5
Rotate the F1 knob to select a wipe pattern or DME
pattern.
To select by entering a pattern number, press the F1
knob, enter the number in the numeric keypad, and
then press the ENTER button.
For pattern numbers, see "Pattern List" (page 188).
6
Set the transition rate as required.
For information about how to set transition rates, see
"Setting Transition Rates" (page 116).
7
Execute the transition by pressing an AUTO TRANS
button or by moving the fader lever.
According to the selected pattern, the next video
gradually wipes the original video away.
Example of wipe transition with pattern
Tips
• Unlike mixes, wipes and DME wipes allow the direction
of the transition to be set.
For details, see "Reversing the directions of transitions"
(page 111).
• You can adjust wipe and DME wipe patterns.
For details, see "Adjusting Wipes and Keys" (page 131).
:
115
Switching Backgrounds
Advertisement
Table of Contents
