Sony DFS-900M Operating Instructions Manual page 137

Sub menu Operation
a) d) Select whether to add
xxx Bevel Color
three-dimensional beveled
(Bevel Color)
edges to an image, and adjust
the color of the beveled edges, if
added.
a) d) Specify the direction and
xxx Border HL
brightness of the light source
(Hilight Setup)
that illuminates beveled edges.
a) xxx: "M/E DME" appears if you are setting up a transition, and "Keyer"
appears if you are setting up a key.
b) Transition sub menu
c) Key sub menu
d) Not available in this version
To display Border sub menus
When using the BKDF-901: Press the SHIFT button in
the DME/SETUP block, lighting it, and then press the
BORDER button.
When using the BKDF-902: Press the BORDER button
in the DME/SETUP block.
The most recently used sub menu appears in the display
panel.
To switch between sub menus, press the h and H
buttons in the numeric keypad.
Border
Border example
Border Color sub menu parameters
Adjust the following parameters to select whether to add a
border, and to adjust the color of the border, if added.
Operation Knob Parameter
Select whether F1 Bod (Border
to add a Enable)
border to an
image.
Adjust the F2 Lum
luminance of (Luminance)
the border.
Adjust the F3 Sat (Saturation)
saturation
(color density)
of the border.
Adjust the hue F4 Hue
of the border.
Inner Width sub menu parameters
Adjust the following parameters to adjust the widths of the
inner sides of the border.
Note
When you add beveled edges to an image, it is not possible
to adjust the widths of the left, right, top, and bottom edges
independently. Set any one of the parameter values.
For information about beveled edge settings, see "Bevel
Color sub menu parameters" (page 138).
Operation
Adjust the width
of the left inner
side border.
Adjust the width
of the right inner
side border.
Adjust the width
of the top inner
side border.
Adjust the width
of the bottom
inner side
border.
Outer Width sub menu parameters
Adjust the following parameters to adjust the widths of the
outer sides of the border.
Note
When you add beveled edges to an image, it is not possible
to adjust the widths of the left, right, top, and bottom edges
independently. Set any one of the parameter values.
For information about beveled edge settings, see "Bevel
Color sub menu parameters" (page 138).
Operation
Settings
Adjust the width
of the left outer
On: Add
side border.
Off: Do not add
Adjust the width
of the right outer
side border.
0.0 to 108.6
Adjust the width
of the top outer
side border.
0.0 to 100
Adjust the width
of the bottom
outer side
border.
0.0 to 359.5
Knob Parameter Settings
F1 L (Left Side) 0 to 200
F2 R (Right Side) 0 to 200
F3 T (Top Side) 0 to 200
F4 B (Bottom 0 to 200
Side)
Knob Parameter Settings
F1 L (Left Side) 0 to 100
F2 R (Right Side) 0 to 100
F3 T (Top Side) 0 to 100
F4 B (Bottom 0 to 100
Side)
Customizing DME Effects
137