Table of Contents
Advertisement
Assigning video input signals to cross-point selection buttons
6
Remove the USB flash drive from the USB MEMORY connector, and load
the file into a computer.
7
Use Notepad or another text editor to edit the display names (the strings
after the equals signs).
The following characters can be used in display names. The maximum
number of characters per name is four.
• Numbers: 0 to 9
• Alphabetic characters: a to z, A to Z
• Space
• Symbols: ! " # $ % & ' ( ) * + , - . / : ; < = > ? @ [ \ ] ^ _ ` { | } ~
Note
• Display names will not be displayed correctly if you use any characters
other than those listed above. If a display name is longer than four
characters, the fifth and following characters are not displayed.
• You can also change the names of channel numbers that have been
assigned to optional input expansion boards. But channel number names
are not displayed for boards that are not installed and for channel numbers
that (depending on the board) are invalid. For information about channel
numbers of input expansion board , see page 39.
8
Save the edited name file to the USB flash drive, overwriting the old file,
and then insert the USB flash drive into the USB MEMORY connector.
9
Repeat steps 2 to 4 to display the Signal Rename sub menu, and then hold
the F4 knob down for one second or longer.
The edited file is read into the switcher, and the signal display names in
menus change to the edited names.
Tip
The dfs900.ini file contains instructions that specify how to display child
window titles in multi-view output (see page 95). You can edit those
instructions to change the display position and size of child window titles.
For details, see page 98.
When using the BKDF-901
Use the following procedure to assign video input signals to PROGRAM and
PRESET selection buttons (BLACK and 1 to 12). Each assignment assigns the
same signal to the PROGRAM and PRESET selection buttons with the same
numbers.
75
Basic Switcher Settings
Advertisement
Table of Contents
