Ld Adjustment - Konica Minolta bizhub C203 Service Manual

10. Service Mode
10.4.8 Exhaust Fan Stop Delay
Functions • To set the period of time before the exhaust fan motor stops.
Use • At the completion of a print job/image stabilization or at jam/malfunction, the fan
motor rotating at full speed comes to a stop. The period of time before the fan motor
stops can be delayed so that ozone left around the PC drum can be discharged.
Setting/ • 0 to 15 (minutes) can be entered with the ten-key pad. (Default is 0.)
Procedure
NOTE
• When this setting is set to 0 (minute), the fan motor runs for 5 seconds before
it stops.
10.4.9

LD adjustment

A. LD delay adjust.
Functions • LD delay adjust sets adjustment values by adjusting LD light emission delay amount.
(Values to be entered are described on the side of the PH unit.)
Use • This setting is made after the PH unit is replaced.
• This adjustment is made when the service EEPROM board is replaced or the backup
of information on position settings is lost.
Setting/ 1. Call the Service Mode to the screen.
Procedure 2. Touch these keys in this order:
[Machine] → [LD adjustment] → [LD delay adjust.].
3. Select the color to be set.
4. Enter the values described on the side of the PH unit using 10-key pad.
5. Touch [OK].
350
Field Service Ver. 1.0 Jul. 2007