Konica Minolta bizhub C203 Service Manual page 371

8. Utility Mode
(4) Authentication Time Setting
• It will be displayed only when the following setting shows that authentication device 1 is
mounted.
[Service Mode] → [Billing Setting] → [Management Function Choice]
Functions • To set the authentication mode when authentication device is used.
Use • To change the authentication mode when authentication device is used.
Keep Card
Touch and Go
• When selecting "Touch and Go", authentication reset is set after completing the job in
[Authentication Time].
Setting/ <Authentication Method>
Procedure • The default setting is Touch and Go.
<Authentication Time>
• The default setting is 1 min.
<Authentication Log-out When Job is Completed>
• The default setting is Yes.
H. Stamp Settings
(1) Apply Stamps
Functions
• Selects whether to add a stamp to documents when jobs are printed or fax/scanned
data is sent.
Use
Setting/ • The each default setting is Do Not Apply.
Procedure
• Touch "Apply" to make stamp settings independently for print and transmission
modes.
(2) Delete Registered Stamp
Functions
• Deletes registered stamps, and copy protect/repeat stamps.
Use
Setting/ 1. Touch [Delete Registered Stamp].
Procedure 2. Select [Stamp] or [Copy Protect/Stamp Repeat].
3. Select [Yes] on the confirmation screen and touch [OK] to delete the registered
stamps.
326
: Authentication is available leaving the card in the given place
when making authentication with the device.
: Card is placed only when authentication is made with the device
and if the card is left for a given time (Authentication reset time)
the authentication setting is reset.
Keep Card
1 to 30 min.
"Yes"
Apply
Field Service Ver. 1.0 Jul. 2007
"Touch and Go"
No
"Do Not Apply"