Advertisement
(9) Install the supplied punch box.
(10) Affix the supplied label to the front door of the
finisher as shown in the illustration.
(11) Reattach the rear cover from the finisher
removed in step (4). (Eight screws)
(12) Install the finisher to the machine.
Note:
<C754e/C654e/C754/C654/C554e/C454e/C364e/
C284e/C224e/C554/C454/C364/C284/C224/C368/
C308/754e/654e/754/654/554e/454e/364e/284e/
224e>
See the installation manual for the Relay unit/Fin-
isher RU-513/FS-534SD or RU-513/FS-534 for
installation instructions.
<367/287/227>
See the installation manual for the Relay Unit/Fin-
isher RU-514/FS-534SD or RU-514/FS-534 for
installation instructions.
3. Configuration procedures
<Punch option setting>
(1) Plug the power cord into the power outlet and
turn ON the power switch.
(2) Display the Service Mode screen.
(For details of how to display the Service Mode
screen, see the service manual.)
(3) Touch "Finisher."
(4) Touch "Punch option setting."
(5) Touch "PK-520" and select a desired number of
holes.
(6) Touch "decision."
(7) Touch "END."
(8) Touch "Exit" on the Service Mode screen.
(9) Turn OFF and ON the power switch.
4. Adjustment procedures
<Punch hole deviance adjustment>
(1) Make a copy in the punch mode.
(Refer to the User's Guide CD)
(2) Fold the copy into halves and check for possible
deviation in the punch hole positions.
Specifications: 0 ± 2.0 mm
Note:
If the positional deviation of the punch holes is not
within the accepted range, take the following
steps.
(3) Open the upper cover of the finisher.
E-3
Advertisement
