Document Width Detection Variable Resistor - Konica Minolta bizhub C203 Service Manual

Field Service Ver. 1.0 Jul. 2007
[2]
4.3.7

Document width detection variable resistor

1. Open the feed cover.
See P.16
[1]
[2]
[2]
[2]
[1] [3]
A01HF2C026DA
A01HF2C015DA
[1]
9J07F2C531DA
3. Remove the screw [1].
4. Remove four screws [2] and remove
the DF control board [3].
NOTE
• Be sure to perform the following
operation when the DF control
board is replaced.
5. Replace the EEPROM.
6. Upgrade the firmware.
See P.50 of the main body service
manual.
2. Disconnect the connector [1] and
remove the document width detec-
tion variable resistor cover [2].
3. Remove two screws [1] and remove
the document width detection vari-
able resistor [2].
4. Other
21