Table of Contents
Advertisement
T2700G-28TQ
JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
T2700G-28TQ#firmware
firmware.bin
ping
Description
The ping command is used to test the connectivity between the switch and one
node of the network.
Syntax
ping ip_addr [-n count] [-l count] [-i count]
Parameter
ip_addr —— The IP address of the destination node for ping test.
-n count —— The amount of times to send test data during Ping testing. It
ranges from 1 to 10. By default, this value is 4.
-l count —— The size of the sending data during ping testing. It ranges from 1 to
1024 bytes. By default, this value is 64.
-i count —— The interval to send ICMP request packets. It ranges from 100 to
1000 milliseconds. By default, this value is 1000.
Command Mode
User EXEC Mode and Privileged EXEC Mode
Example
To test the connectivity between the switch and the network device with the IP
192.168.0.131, please specify the count (-l) as 512 bytes and count (-i) as 1000
milliseconds. If there is not any response after 8 times' Ping test, the connection
between the switch and the network device is failed to establish:
T2700G-28TQ#ping 192.168.0.131 –n 8 –l 512
tracert
Description
The tracert command is used to test the connectivity of the gateways during its
journey from the source to destination of the test data.
upgrade
ip-address
162
192.168.0.148
filename
Advertisement
Table of Contents
