Snmp-Server Traps Mac - TP-Link T2700G-28TQ Cli Reference Manual

T2700G-28TQ JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
flash —— Enable flash trap. It is sent when flash is modified during operations
such as backup, reset, firmware upgrade, configuration import, etc.
ipaddr-change —— Enable ipaddr-change trap. It is sent when IP address is
changed such as user manually modifies the IP address or the switch obtains a
new IP address from DHCP.
lldp —— Enable lldp trap. It is sent when the port's neighbor changes.
loopback-detection —— Enable loopback-detection trap. It is sent when the
switch detects loopback or loopback is cleared.
storm-control —— Enable storm-control trap. It is sent when the multicast or
broadcast rate exceeds the predefined value.
spanning-tree —— Enable spanning-tree trap. It is sent when the port forwarding
status changes or the port receives TCN packet or packet with TC flag.
memory —— Enable memory trap. It is sent when CPU usage exceeds 80%.
Command Mode
Global Configuration Mode
Example
Enable SNMP extended bandwidth-control trap for the switch:
T2700G-28TQ(config)# snmp-server traps bandwidth-control

snmp-server traps mac

Description
The snmp-server traps mac command is used to enable SNMP extended
MAC
learn-mode-change and max-learned. To disable the sending of SNMP
extended MAC address related traps, please use no snmp-server traps mac
command.
Syntax
snmp-server traps mac [ new | full | learn-mode-change | max-learned ]
no snmp-server traps mac [ new | full | learn-mode-change | max-learned ]
Parameter
new —— Enable new MAC address trap. It is sent when the switch learns new
MAC address including dynamic address, static address and filter address.
full —— Enable MAC address table trap. It is sent when the MAC address table
is full.
address-related traps
256
which include four types: new, full,