Table of Contents
Advertisement
T2700G-28TQ
JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
Example
Specify Fast Start Count as 5:
T2700G-28TQ(config)# lldp med-fast-count 5
lldp med-status
Description
The lldp med-status command is used to enable the LLDP-MED feature for the
corresponding port. After the LLDP-MED feature is enabled, the port's Admin
Status will be changed to Tx&Rx. To disable the LLDP-MED feature for the
corresponding port, please use no lldp med-status command.
Syntax
lldp med-status
no lldp med-status
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Enable the LLDP-MED feature for port 1/0/2:
T2700G-28TQ(config)# interface gigabitEthernet 1/0/2
T2700G-28TQ(config-if)# lldp med-status
lldp med-tlv-select
Description
The lldp med-tlv-select command is used to configure LLDP-MED TLVs to be
included in outgoing LLDPDU for the corresponding port. To exclude
LLDP-MED TLVs, please use no lldp med-tlv-select command. By default, All
TLVs are included in outgoing LLDPDU.
Syntax
lldp
[power-management] [all] }
no lldp med-tlv-select { [inventory-management] [location] [network-policy]
[power-management] [all] }
med-tlv-select
{
[inventory-management]
273
[location]
[network-policy]
Advertisement
Table of Contents
