Table of Contents
Advertisement
T2700G-28TQ
JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
Parameter
level —— Severity level of the log message. There are 8 severity levels marked
with values 0-7. The smaller value has the higher priority. Only the log with the
same or smaller severity level value will be saved to the flash. By default, it is 2
indicating that the log message marked with 0-2 will be saved in the log flash.
Command Mode
Global Configuration Mode
Example
Save the log messages with their severities equal or higher than 7 to the flash :
T2700G-28TQ(config)#logging file flash level 7
logging host index
Description
The logging host index command is used to configure the syslog server hosts
to receive logging messages. To clear the configuration of the specified Log
Host, please use no logging host index command. Log Host is to receive the
system log from other devices. You can remotely monitor the settings and
operation status of other devices through the log host.
Syntax
logging host index idx host-ip level
no logging host index idx
Parameter
idx ——The index of the log host. The switch supports 4 log hosts.
host-ip —— The IP for the log host.
level ——The severity level of the log information sent to each log host. There
are 8 severity levels marked with values 0-7. The smaller value has the higher
priority. Only the log with the same or smaller severity level value will be sent to
the corresponding log host. By default, it is 6 indicating that the log information
marked with 0-6 will be sent to the log host.
Command Mode
Global Configuration Mode
121
Advertisement
Table of Contents
