Dot1X Port-Control - TP-Link T2700G-28TQ Cli Reference Manual

T2700G-28TQ JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
Example
Enable the Guest VLAN function for Gigabit Ethernet port 1/0/2:
T2700G-28TQ(config)#interface gigabitEthernet 1/0/2
T2700G-28TQ(config-if)#dot1x guest-vlan

dot1x port-control

Description
The dot1x port-control command is used to configure the Control Mode of
IEEE 802.1X for the specified port. By default, the control mode is "auto". To
restore to the default configuration, please use no dot1x port-control
command.
Syntax
dot1x port-control {auto | authorized-force | unauthorized-force}
no dot1x port-control
Parameter
auto | authorized-force | unauthorized-force —— The Control Mode for the port.
auto: In this mode, the port will normally work only after passing the 802.1X
Authentication.
authorized-force: In this mode, the port can work normally without passing the
802.1X Authentication.
unauthorized-force: In this mode, the port is forbidden working for its fixed
unauthorized status.
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Configure the Control Mode for Gigabit Ethernet port 20 as "authorized-force":
T2700G-28TQ(config)#interface gigabitEthernet 1/0/20
T2700G-28TQ(config-if)#dot1x port-control authorized-force
112