Table of Contents
Advertisement
T2700G-28TQ
JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
Example
To enter the Interface gigabitEthernet Configuration Mode and configure
Ten-Gigabit Ethernet port 25:
T2700G-28TQ(config)#interface ten-gigabitEthernet 1/0/25
interface range ten-gigabitEthernet
Description
The interface range ten-gigabitEthernet command is used to enter the
interface range ten-gigabitEthernet Configuration Mode and configure multiple
Ten Gigabit Ethernet ports at the same time.
Syntax
interface range ten-gigabitEthernet port-list
Parameter
port-list —— The list of Ten Gigabit Ethernet ports.
Command Mode
Global Configuration Mode
User Guidelines
Command in the Interface Range ten-gigabitEthernet Mode is executed
independently on all ports in the range. It does not affect the execution on the
other ports at all if the command results in an error on one port.
Example
To enter the Interface Range ten-gigabitEthernet Configuration Mode, and
configure Ten Gigabit Ethernet ports 25 and 26 at the same time by adding them
to one port-list:
T2700G-28TQ(config)# interface range ten-gigabitEthernet 1/0/25-26
174
Advertisement
Table of Contents
