Ip Igmp Snooping Querier Vlan - TP-Link T2700G-28TQ Cli Reference Manual

T2700G-28TQ JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
member-time —— Member Port Time. Within this time, if the switch does not
receive IGMP report message from the member port, it will consider this port is
not a member port any more. Member Port Time ranges from 60 to 600 in
seconds. By default, it is 260.
leave-time —— Leave Time, which is the interval between the switch receiving
a leave message from a host and the switch removing the host from the
multicast groups. Leave Time ranges from 1 to 30 in seconds. By default, it is 1.
port —— Static Router Port, which is mainly used in the network with stable
topology.
Command Mode
Global Configuration Mode
Example
Enable Multicast VLAN 3, and configure Router Port Time as 100 seconds:
T2700G-28TQ(config)#ip igmp snooping multi-vlan-config 3 rtime 100

ip igmp snooping querier vlan

Description
The ip igmp snooping querier vlan command is used to enable the IGMP
Snooping Querier function of the VLAN(s). To disable the IGMP Snooping
Querier function of certain VLANs, please use no ip igmp snooping querier
vlan command.
Syntax
ip igmp snooping querier vlan vlan-id
no ip igmp snooping querier vlan vlan-id
Parameter
vlan-id — VLAN ID, ranging from 1 to 4094.
Command Mode
Global Configuration Mode
Example
Enable the IGMP Snooping Querier function of VLAN1:
T2700G-28TQ(config)#ip igmp snooping querier vlan 1
240