Table of Contents
Advertisement
T2700G-28TQ
JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
Command Mode
Global Configuration Mode
Example
Create the loopback interface 1:
T2700G-28TQ(config)# interface loopback 1
switchport
Description
This switchport command is used to switch the Layer 3 interface into the Layer
2 port. To switch the Layer 2 port into the Layer 3 routed port, please use the no
switchport command.
Syntax
switchport
no switchport
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Switch the gigabitEthernet port 1/0/9 into the routed port:
T2700G-28TQ(config)# interface gigabitEthernet 1/0/9
T2700G-28TQ(config-if)# no switchport
shutdown
Description
This switchport command is used to shut down the specified interface. The
interface type include: routed port, loopback interface and VLAN interface. To
enable the specified interface, please use the no shutdown command.
Syntax
shutdown
no shutdown
289
Advertisement
Table of Contents
