1.1.2 Configuring The Privileged Exec Mode Password; 1.1.3 Logon By Telnet - TP-Link T2700G-28TQ Cli Reference Manual

T2700G-28TQ JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide

1.1.2 Configuring the Privileged EXEC Mode Password

To configure the switch remotely by a Telnet or SSH connection, please set a password for
entering the Privileged EXEC Mode through the console connection first. Follow the steps in 1.1.1
Logon by a console port to log on to the switch, and then follow the steps shown in Figure 1-6 to
configure the Privileged EXEC Mode password.
Figure 1-6 Configure the Privileged EXEC Mode Password

1.1.3 Logon by Telnet

For Telnet connection, after configuring the Privileged EXEC Mode Password, you should also
configure the Telnet login mode and login authentication information through console connection.
Telnet login has the following two modes. You can choose one according to your needs:
Login local Mode: It requires username and password, which are both admin by default.
Login Mode: It doesn't require username and password, but a connection password is required.
Note:
Before Telnet login, you are required to configure Telnet login mode and login authentication
information through console connection.
8