Interface Ten-Gigabitethernet - TP-Link T2700G-28TQ Cli Reference Manual

T2700G-28TQ JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
Syntax
interface range gigabitEthernet port-list
Parameter
port-list —— The list of Gigabit Ethernet ports.
Command Mode
Global Configuration Mode
User Guidelines
Command in the Interface Range gigabitEthernet Mode is executed
independently on all ports in the range. It does not affect the execution on the
other ports at all if the command results in an error on one port.
Example
To enter the Interface Range gigabitEthernet Configuration Mode, and configure
Gigabit Ethernet ports 10, 11 and 18 at the same time by adding them to one
port-list:
T2700G-28TQ(config)# interface range gigabitEthernet 1/0/10-11,1/0/18

interface ten-gigabitEthernet

Description
The interface ten-gigabitEthernet command is used to enter the interface
ten-gigabitEthernet Configuration Mode and configure the corresponding Ten
Gigabit Ethernet port.
Syntax
interface ten-gigabitEthernet port
Parameter
port —— The Ten Gigabit Ethernet port number.
Command Mode
Global Configuration Mode
173