Spanning-Tree Mode - TP-Link T2700G-28TQ Cli Reference Manual

T2700G-28TQ JetStream 28-Port Gigabit Stackable L2+ Managed Switch CLI Guide
designated port, they can transit their states to forwarding rapidly to reduce the
unnecessary forward delay.
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet /
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Enable the STP function of Gigabit Ethernet port 1/0/1, and configure the Port
Priority as 64, ExtPath Cost as 100, IntPath Cost as 100, and then enable Edge
Port:
T2700G-28TQ(config)#interface gigabitEthernet 1/0/1
T2700G-28TQ(config-if)#spanning-tree common-config port-priority 64
ext-cost 100 int-cost 100 portfast enable point-to-point open

spanning-tree mode

Description
The spanning-tree mode command is used to configure the STP mode of the
switch. To return to the default configurations, please use no spanning-tree
mode command.
Syntax
spanning-tree mode {stp | rstp | mstp}
no spanning-tree mode
Parameter
stp —— Spanning Tree Protocol, the default value.
rstp —— Rapid Spanning Tree Protocol
mstp —— Multiple Spanning Tree Protocol
Command Mode
Global Config
Example
Configure the spanning-tree mode as "mstp":
T2700G-28TQ(config)#spanning-tree mode mstp
uration Mode
220